This set has been fully refurbished with a new case, all new seals, switch thumbwheels and backplate. The inner parts were checked and serviced as required and set up again as per it's specifications. The work was done by a radio engineer. The set is now spot on spec and ready to go.

ALL THE RADIOS I SUPPLY ARE COVERED BY A 30 DAY WARRANTY, IF IT DOESN’T WORK I WILL EXCHANGE IT FOR ANOTHER RADIO OF THE SAME TYPE

                                                             Clansman PRC-349

This was the standard Hand-held radio of the British army, part of the "Clansman" series of "RACAL" radio equipment. This set has been tested and is bang on spec and frequency.

The PRC-349 is a VHF/FM radio with HALF A WATT OUTPUT and a frequency range, 37 to 46.975 MHz in 25 KHz steps providing 400 possible channels and a maximum output power of 1 Watt. Frequency selection is by small thumb wheel switches on the side of the radio. Has Clansman compatible squelch and whisper modes of operation with battery saving function. Operates from 9.5 to 16v DC using AA batteries or rechargable NiCad batteries.

It comes with a new standard headset with throat mic and mini clip on pressel box, a new carrying case/harness, a new battery cassette to hold 10 x 1.5v batteries, a new 4 section base loaded folding steel antenna, a used and in good condition 0.6m flexible rubber whip antenna, a virtually new NiCad battery fully charged and a genuine user manual. All in an as new waterproof GS ancillaries bag

The PRC-349 is an VHF/FM transceiver intended for personal communication in combat conditions. The radio is designed to be fully compatible with the existing range of Clansman VHF equipment, 350-351-352-353 etc.
The radio can be mounted on the shoulder, chest or back with adjustable quick release straps and holster. It can also be carried inside a back pack or on a belt mounted holster, or simply the pocket of a combat jacket.

Intended for platoon level personal communications under combat conditions. Protection from open or short circuit and receiver overload is inbuilt. A battery saver function is in automatic operation during no-signal conditions.

All funds must have cleared before posting or collection.